First Cap kit, flyback, width coil - big purity problem

Brooklyn

Member
Joined
May 21, 2006
Messages
212
Reaction score
3
Location
Morgan Hill, California
First Cap kit, flyback, width coil - big purity problem

Hi, I just did my first cap kit on a worn G07 Pacman monitor. I also did the horizontal width coil and flyback.

I turned it on its working pretty good, but the purity in the center of the screen is way off. I tried messing with the yoke location but it just moves it up or down, does not eliminate the color distortion.

What can I do? See picture. I would say de-gauss, but isn't that usually around the edges? This is placed right in the middle.
 

Attachments

  • photo (9).jpg
    photo (9).jpg
    77.6 KB · Views: 45
yes, i have monitors that have color problems like that from time to time. the last thing you want to do is move the yoke cause you mess up the convergence of the colors. degauss and see what happens first.
 
Well I feel dumb, I took the butt end of my solder gun and de-gaussed the screen and it's gone. Too much over thinking the problem apparently!

I purposely turned up the red in the picture to show the problem, so I was able to adjust that back as well.
 
Back
Top Bottom