Firepower II will not start

89pin

New member
Joined
Feb 16, 2010
Messages
53
Reaction score
1
Location
Wayne, New Jersey
I had a boot issue and cleared that up by replacing the 40 pin giant connector. Now im back to square 1 where it will go into attract mode and take coins but will not play. This was the problem before the boot issue. I traced back the wires wit a ddm and it is getting signal in "beeper mode" to the conector on the driver board. Connector replacement?
 
All the balls must be on the ball trough switches or the game will not start.

Check the outhole switch, both ball trough switches, and the shooter lane switch to make sure the switches are good and there are no broken wires.
 
Thanks ken! i did though all that, got it to half play. No pop bumpers or other selinoids worked. im thinking its plaqued with connector issues. Ill start by replacing the selinoids molex connector
 
Back
Top Bottom