Fine Tuning -> Focusing Correctly... Nanao m8-26su

[zasteeg]

So, I switched some stuff around, and crazy....

Red = Blue
Blue = Green
Green = Red

Picture looks good now. All I need now is a degauss and some tuning and put back together. I'm surprised the colors do not match up at all.

I will post some pictures, but the degauss button I attached doesn't seem to work. Any ideas?

Thanks,
zasteeg

 

[zasteeg]

Thanks to cadillacman:

aha!!! http://www.antelopearcade.com/manual...r Manual.pdf

CHeck out page 44. looks like one side of that 2 pin connector goes to ac common, the other goes from the 120v(hot) through a pushbutton switch and then to the other pin on the monitor.

 

[zasteeg]

Update:

So, after correctly setting up the degaussing pushbutton, the colors are mixed up again. (earlier we had to switch RBG around). So I switched them to the original setup Red on Red, Blue on Blue ect, and works great! Degaussing worked great as well.

Only question I have now is a couple real small lines on the top of the screen that run horizontal all the way across. They are small but it still works great.

 

[cadillacman]

Update:

So, after correctly setting up the degaussing pushbutton, the colors are mixed up again. (earlier we had to switch RBG around). So I switched them to the original setup Red on Red, Blue on Blue ect, and works great! Degaussing worked great as well.

Only question I have now is a couple real small lines on the top of the screen that run horizontal all the way across. They are small but it still works great.

wtf? so it was so magnatized the colors swapped with each other? LOLS well that explains why the wires "werent matching up"

ive had a couple nanaos some did that, some did not. I assumed caps or some adjustment but didnt ever care enough to dig into it as they worked well otherwise.