You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
Museum of the Game® & International Arcade Museum® Forums
Hello, so I am working on my Enduro Racer cabinet again and it's having problems with the light and monitor. Of course I just got my replacement Smartypi board and now it wants to start acting up. The ends of the light bulb are illuminated while the middle will not. The monitor turns on for a few seconds as I can hear the high voltage, then it shuts off. When I measured the voltage going to the monitor I was getting 123V, not sure if that's too high or not. (The monitor is a K7000). Already tried testing the light and monitor one at a time but still get the same problem. Any suggestions?
Attached picture shows how the bulb looks, and of course monitor keeps shutting off.