Museum of the Game® & International Arcade Museum® Forums

Hello there-

I recently purchased a cap kit for an Electrohome G07-CBO 19" Monitor from Happs and it had some additional instructions on a sync modification which prevents horizontal curl. The instructions are pretty vague and have me replace two ceramic capacitors (no polarity) with two electrolytic capacitors which we all know are polarity sensitive and could burst if installed incorrectly.

The instructions are:

On the mother board, replace C303 with the 10 uF @ 50V radial lead capacitor with the positive lead connected to the collector of X305. Then replace C501 with the capacitor taken from space C303.

I am pretty sure I have the C303 one figured out but some verification would be appreciated. As for the C501 (non polarity) capacitor, I'm really unsure which way to install it since its replacement is an electrolytic capacitor which has polarity.

I hope I explained this clear enough....please help...

Thanks a million as always.

Back
Top Bottom