Donkey Kong Video Problem

andrewuts1

Active member
Joined
Nov 5, 2007
Messages
397
Reaction score
53
Location
Bettendorf, Iowa
I keep getting verticle "blips" in the middle of my screen. It's usually not noticable until I have played a few levels. As I turn my +5v up it gradually gets better. It is currently at 5.9 and is barely noticable. If it is left at 5.1 or so it is much, much, worse. Do I turn it up a bit higher to get it to go away? Any ideas? I have a new cap kit on it. Thanks, Andy
 
Any idea where to start? I am obviously concerned about turning it up anymore. But I thought maybe I have a strange board that needs a little more juice. Andy
 
can you post pics or a video? i would check your edge connector to make sure it's seated properly. check the board interconnect cables. make sure all socketed chips are seated in the sockets. etc.
 
Back
Top Bottom