Donkey Kong PCB shelf

JoeB1355

Well-known member
Joined
Dec 11, 2010
Messages
1,631
Reaction score
99
Location
Seymour, Tennessee
Anyone have the dimensions of the wood squares with the slots that go for the PCB on the shelf?

Mine was removed for a VS conversion

picture of my missing ones and someone else's correct and non-missing ones


I can guess but if someone has the measurements it would be easier
 
Last edited:
If yours is the first pic, it looks like you can tell from the marks of where the original pieces were. I'd use 3/4x3/4 square strips, then cut a 1/16" slot with a slot cutter or run it over a narrow kerf blade on a table saw, if you don't mind losing your fingers.
 
Back
Top Bottom