Donkey Kong Cocktail Monitor Wiring

flamekid99

New member
Joined
Mar 14, 2010
Messages
10
Reaction score
0
Location
napa, California
Just bought a broken DK Jr cocktail and it did not come with any wiring harness's at all to go to the monitor. Does anyone have any pics or schematics that show these connections. I need the video and the power connections. Thanks in advance. -K
 
welcome.


I don't have an pics handy, but the power for the monitor is just a standard 2 prong power cord that plugs into an outlet in the bottom of the cab. don't plug it into a wall outlet though.

there are three other sets of wires that go to the monitor, they are located near the pcb.

the first is a 6 wire set that has the rgb sync x2 and ground wires. this will be a flat 6 pin ribbon cable that connects to the inverter board on the monitor.

the second set is black and white wire (maybe brown and white) which is the unamplified sound going to the amp. this is a 2 wire connector.

the third is a red and white two wire connector that comes from the sound amp and goes to the speaker.

the wires are probably dangling somewhere near the pcb.


good luck.
 
unless some chucklehead cut the connectors off, they should still be part of the wiring harness. follow the wire from the speaker and see where it leads, the 3 sets should be bundled together.
 
The speaker goes about 6 inches and ends with a molex connector. And nothing connects to the monitor. I'm flying blind here.
 
Alright so I got the wiring for the sound and the video cable. Still no sound or video...Yay. Where should I go from here?
 
Make sure the game is on? Check for 100vac at the outlet in the bottom for the monitor to plug into. If there is no voltage, then the game isn't on and you need to check fuses, etc. If there is voltage but the monitor doesn't work (and your sound is part of the monitor), then you probably have a dead monitor...
 
Back
Top Bottom