DKJR REWiring cables too board Needing help!

simpsons99

New member
Joined
Apr 20, 2003
Messages
4,448
Reaction score
5
Location
Snohomish Washington
Just checking before i power this back up.. There should not be anything plugged into the P6 Plugging?

The same pinout cable is used for the Raindow cable on the other side of the board.
 
P6 is only needed if using the edge connector type harness.
P3 on the video board is used for the original little black connector type harness.
A cable runs directly from 10P,on the power supply,to P3 to power the video board.
 
TY for responding .. I was pretty sure i was right after looking at my DK wiring and pretty much saw the samething... But i thought it could'nt hurt too ask before powering the machine up!
 
Back
Top Bottom