DKJ control panel wiring

tonystein23

Member
Joined
Jul 21, 2010
Messages
60
Reaction score
1
Location
Pennsylvania
I was replacing my cpo and as i put the control panel back into place, the wiring came loose from the harness and one of the pins broke off. Any suggestions? Is there a place I can buy a wiring harnes and just rewire it? Can I just take out the wires of the connecter and install them in a new connector? If so where could I purchase the connector?
 
Last edited:
thank you! that is exactly what I am looking for. Now is all I have to do is pull the wires from the one and insert them in the new one? Is there any tricks I should be aware of?
 
I think the wires were cut right at the connector,so I just crimped new pins on the wires and inserted them into the connectors.
I have never tried to remove the existing pins from the connectors to replace them.
If there is enough length to the wire then just do what I did if you can't remove the pins from the connectors.
 
Back
Top Bottom