DK3 Sanyo Wave

thefader

New member
Joined
Jun 21, 2010
Messages
953
Reaction score
1
Location
South Dakota
This monitor has a brand new cap kit, including the filter cap...

What else can be causing the wave?

I read it can be caused by the monitor ground not being hooked up correctly. If this is from the green ground cable in the cabinet, where does it hook upto on the monitor? And what else can be causing this? Thanks.
 
there's an IC too that can cause it. I have the same shit on my DK. unfortunately for me, my hiding spot for the NEW regulator I bought has eluded me, and I still have yet to replace it. fffffffffffffffffffffffffffuuuuuuuuuuuuuu

it's the one close to the B+ pot. I think it's like VR6 or something like that, I can't remember.
 
never fixed it on my DK, like I said I bought a new voltage regulator, hid it somewhere so it wouldn't get lost, and conveniently lost it. :D

I did everything else, no change at all.
 
I just checked the voltage, it was at 92.5v on the test point. But the B+ Adj is destroyed, like on all my other DK machines, so ill start by replacing that.
 
yeah, they're such garbage pots. had to scalp one off another chassis cause when I broke that whiteout looking shit off it, it broke the pot too. heh wouldn't adjust at all.
 
Mr. Bob Roberts has them, 1 Dollar each, and they have a nice hard red plastic adjuster piece. I put one on a monitor that wouldnt adjust and it works great now.
 
Back
Top Bottom