DK Coin Up

bbeckwith

Active member
Joined
Apr 13, 2012
Messages
1,953
Reaction score
17
Location
Kansas City, Missouri
I was wondering, since I don't have my switch for my coin doors or counter, is there a way to coin up my game in any way? I have the 3 pin connector that goes into the "coin" spot on the CPU board.... didn't know if I could run a few wires out of it and touch them to coin it or what?
 
Just touch the wires together to coin it up.
All the switch does is complete the circuit when depressed.
You could even hook the 2 wires up to a button switch if you have one lying around.
The connector is 3 circuit but should have only 2 wires.
The connector uses only the 2 outer pins and not the center one.
 
I take it you aren't using a Sanyo monitor.
If yes then you don't need an inverter.
If not there has been one on ebay for a while now.
 
I take it you aren't using a Sanyo monitor.
If yes then you don't need an inverter.
If not there has been one on ebay for a while now.

correct Im not using the sanyo monitor. I have an inverter from Mikesarcade... but when I hook it up, I get a majorly scrambled picture. But when the colors are not inverted, the graphics look fine, the colors are off, but that is the only problem.

Here is the post about my video problems

http://forums.arcade-museum.com/showthread.php?t=238976&page=3
 
Inverter

Hey guy, i have an extra nintendo sanyo inverter.. Is that what you need? Pm me.
 
Back
Top Bottom