Cacker
New member
Hi
I've drawn my original DK Coin Door in Solid Edge and looks great and I'm wondering if it's worth getting some made ?
The door itself is easy, but the frame is actually four pieces welded together and this will have an impact on the cost.
I was thinking of making the frames flanges that sit in the hole in the cabinet, just a simple fold, rather than the complicated way the original is done, as this might help reduce the cost.
From the outside, the door and part of the frame you see will be as original.
Any thoughts anyone ?
Cheers
Frank
I've drawn my original DK Coin Door in Solid Edge and looks great and I'm wondering if it's worth getting some made ?
The door itself is easy, but the frame is actually four pieces welded together and this will have an impact on the cost.
I was thinking of making the frames flanges that sit in the hole in the cabinet, just a simple fold, rather than the complicated way the original is done, as this might help reduce the cost.
From the outside, the door and part of the frame you see will be as original.
Any thoughts anyone ?
Cheers
Frank
