DK 4 Board stack power wiring

Quarter Arcade has the 9 & 10 pin wires but not the 7 pin.
You could always make the 7 pin wire or maybe see if Dokert can make one up for you.
 
I might have it... let me send you a picture later today so you can confirm (it's on my PC at work). If I do have it... I'll send it to you. You can hook me up with something I need down the road. Fair?
 
Yes? I can't tell if you have a 7 pin in there or not. Count the pins on the larger black wafer connectors. I see a nine pin and a ten, but I can see a 7.
 
I'll check tonight. I took the picture last weekend while I was going through stuff in storage. I do remember there were 3 different wire bundles. I'll let ya know.
 
OK... it's official... no 7 pin connector in the bunch. There are 3 bundles. I have included a single picture of each. 1 of them has 2 plugs on one end and a single, larger plug on the other. If you want them Phet, PM me your address and I'll send them up I-94 on Monday.
 

Attachments

  • Dscf2456.jpg
    Dscf2456.jpg
    32.9 KB · Views: 5
  • Dscf2457.jpg
    Dscf2457.jpg
    32.4 KB · Views: 4
  • Dscf2458.jpg
    Dscf2458.jpg
    37 KB · Views: 5
OK... it's official... no 7 pin connector in the bunch. There are 3 bundles. I have included a single picture of each. 1 of them has 2 plugs on one end and a single, larger plug on the other. If you want them Phet, PM me your address and I'll send them up I-94 on Monday.

1 of them has 2 plugs on one end and a single, larger plug on the other
That is the board to CP cable.


The others are power to board cables
 
Still looking for the 7 pin power connector, and I will PM you my address for the stuff you've got alejandromad. Thank you so much.
 
Yes, yes I am. I was waiting until your DK3 harness building wound down to ask you if you'd make me one. If an original popped up in the meantime, bonus. If you have the means to make one of these, I'll take one.

Sir, Phet... it is easy to make one. I have a homemade one on my Radarscope that Mark made.

Jameco should have the connectors:

Not sure if this is right, but something like this?:

http://www.jameco.com/webapp/wcs/st...toreId=10001&catalogId=10001&productId=103203

http://www.jameco.com/webapp/wcs/st...amecoall&ddkey=http:StoreCatalogDrillDownView

The above is an 8 pin connector. You'd have to cut the one end off.

I can take a photo of Mark's homemade one tonight, if you'd like.
 
Last edited:
OK, Barry is making me a 7 pin power cable. Now I need the other two, 9 and 10. And the rest of the 4 board harness if anyone has one. I can piece one together from my mountain of parts, or you can make it easy on me. What's it gonna be?
 
Back
Top Bottom