Distortion in Corner?

MasterFygar

Well-known member
Joined
Oct 3, 2009
Messages
3,517
Reaction score
747
Location
Virginia
A cab I'm looking at has some distortion in one of the bottom corners, like when it stretches out some and looks kind of like it's being pulled down. It's not very major and shouldn't affect gameplay but I know literally nothing about monitor issues... is that a sign that the monitor is going, and is likely to get worse? Thanks!
 
yea... degauss then check to make sure your convergence rings or yoke isnt loose
 
I'd say sync or osc. issue.

When I have my machines on the hairy edge of sync (or horizontal osc. on 4600's) I get the same pulling.
 
Some monitors will have little nubs sticking out from the yoke that have small square magnets on them. If yours has that then you might need to give the magnet down on that corner a little twist.
 
Back
Top Bottom