dirty harry playing dirty

katoskave

Permanently Banned - Uses multiple accounts to sca
Joined
Dec 21, 2011
Messages
456
Reaction score
0
Location
Alaska
I keep getting an error that says opto trough bad, check connectors, check wires, check 12v. Its getting proper voltage and the connectors are good. what does this error mean? Also the game would start and the minute you try and launch the ball it would reset. any ideas on that one?
 
Go ahead, make my day!
 
I would get into the test menu and see if the balls in the trough are registering and go from there. Not sure on the reset, other than making sure the wall voltage is high enough.
 
I keep getting an error that says opto trough bad, check connectors, check wires, check 12v. Its getting proper voltage and the connectors are good. what does this error mean? Also the game would start and the minute you try and launch the ball it would reset. any ideas on that one?

Also look at the 4 small connectors on the driver board lower left side. I had a couple games with issues similar to yours and had to replace the .156 pins.
 
the gi light connector is burnt no suprise there. nothing else is damaged in the box. I am going to recheck fuses here in a few!
 
Back
Top Bottom