MRCMRC
Member
[SOLVED] Dig Dug amp problem
Hello.
I'm making an adaptor to connect my Dig Dug PCB on a Jamma cab. I'm building a small amp for the sound, just this one:
http://pfnicholls.com/electronics/lm380.html
I'm not using C2 between LM380 pin 1 and GND. I use a pot of 10K, and the negative input is connected to GND.
When I move the pot, nothing happens (no sound), until I get a position of the pot, where there is sound. Moving a little the pot from this position makes the sound disappear.
Do you know what am I doing wrong?
Thanks for the help.
Hello.
I'm making an adaptor to connect my Dig Dug PCB on a Jamma cab. I'm building a small amp for the sound, just this one:
http://pfnicholls.com/electronics/lm380.html
I'm not using C2 between LM380 pin 1 and GND. I use a pot of 10K, and the negative input is connected to GND.
When I move the pot, nothing happens (no sound), until I get a position of the pot, where there is sound. Moving a little the pot from this position makes the sound disappear.
Do you know what am I doing wrong?
Thanks for the help.
Last edited: