Defender Help Please

Dokert

Well-known member
Joined
Jun 3, 2007
Messages
12,751
Reaction score
141
Location
Arlington, Washington
I do NOT have a Defender cab, and I need a couple of measurements please from someone who does have a Defender cab.

Measurement #1 From 4J3 on the power supply to the bottom of the cab.

Measurement #2 From the bottom of the cab on the circuit board side to the closest edge of the Isolation transformer.

Thank You for your help.
Dave
 
I do NOT have a Defender cab, and I need a couple of measurements please from someone who does have a Defender cab.

Measurement #1 From 4J3 on the power supply to the bottom of the cab.

Measurement #2 From the bottom of the cab on the circuit board side to the closest edge of the Isolation transformer.

Thank You for your help.
Dave

I will pull out my Defender after everyone goes to bed.
 
I also need the same measurements from any one of the following...

Bubbles
Joust
Robotron
Sinistar

There very well could be a FREE prototype in it, if you meet the eligibility requirement.
 
I do NOT have a Defender cab, and I need a couple of measurements please from someone who does have a Defender cab.

Measurement #1 From 4J3 on the power supply to the bottom of the cab.

Measurement #2 From the bottom of the cab on the circuit board side to the closest edge of the Isolation transformer.

Thank You for your help.
Dave


You do know that the power supply board is part of the power brick on the bottom of the Defender cabs? So measurement #1 is from 4J3 on the power brick to the coin door connector?

Or if you are looking for the distance from the transformer to 4J3, most of the unhacked cables are approximately 14", which seems like overkill since the board is only a couple of inches away from the transformer. I don't have one mounted in my Defender, but I do have a complete power brick I can take more accurate measurements from, once I get home from work.

If I can find my camera I can probably even get photos for you.

ken

Gaak: I meant Transformer to 4J1.
 
Yep, Ken you are correct. I need the measurement from 4J3 to the closest edge of the isolation transformer for Defender. (On the power brick) I don't need any pics, just measurements.

I will need the previously stated measurements for a Stargate with the Defender style power supply also.
 
Stargate & MakeTrax & possibly Moon Patrol all used the same Transformer + usual AC wiring + power supply board on one long skinny power brick. I say possibly Moon Patrol because mine was hacked with a switcher and I never really looked to see if the holes lined up for an old or new ps board.

ken
 
Back
Top Bottom