D9200 cap listing?

[modessitt]

It's been so long since I did one, I can't seem to find my cap listing for the D9200. I replaced the HOT to get the ticking to stop, and it has some stability issues in any mode (will alternate between a full staticy picture to snapping to a smaller pic and back again). I want to do the cap kit to see if it improves before I move on to other troubleshooting (and to make sure the caps aren't causing it).

PM me if you have cap listing, thanks....

 

[modessitt]

Bumpdiddlyump...

 

[KenLayton]

The only place i have even seen a kit for the 9200 is right at Wells-Gardner's parts department:

S-KIT CAP-2792 is just $10.

 

[modessitt]

Well, I was going to build my own kit so I could get it done sooner. Thought I kept the listing from the last time I did one, but can't find it anywhere.


Oh, and for those of you who wish they had a schematic of the D9200, it appears that the 29" Vision Pro (which is actually a 27") is a copy of the D9200. Worked on both this week, and other than a couple part number differences, the board layout is almost exactly the same - and the 29" VP schematic is available on arcarc...

 

[2600]

Schematic with parts list is listed on the Wells Gardner site. Should only take you a few minutes to gather up a Cap list out of that.

 

[modessitt]

Did they put one up finally? They never used to have one...

 

[2600]

Been up there for years as far as I know. I've used it a few times even though I have a paper copy.