DJLC
Member
I built myself a replacement remote board for a D9200 I bought recently. The board, however, can only display the settings menu. I can't navigate through the pages as the buttons do nothing (other than the menu button). I then took a wire to manual connect each pin to ground and it did the same thing.
Anyone know why this is?
Also, whenever I had my atomiswave hooked up via the VGA port and set to 15K res, the monitor made a clicking sound and flickered the image pretty hard. Whenever I changed it to 31k, the clicking went away and the picture looked fine. Do I need to use the other port for 15k resolution?
Thanks guys!
Anyone know why this is?
Also, whenever I had my atomiswave hooked up via the VGA port and set to 15K res, the monitor made a clicking sound and flickered the image pretty hard. Whenever I changed it to 31k, the clicking went away and the picture looked fine. Do I need to use the other port for 15k resolution?
Thanks guys!