Picked up a Crusin' sit-down and finally got to looking at it. Basically, it comes on when I flip the switch, I hear two beeps, and nothing else. The monitor was pulled out and they put a VGA monitor in and the converter has a broken pin, so just looking for it to play blind.
I checked the voltages from the power supply and I got what I need. I checked all the fuses, good. Checked the voltages at the connector and I'm good there.
I have no D6 light on the board, and from what I understand the D7 should be off. I'm in the dark with my limited knowledge on this board and am looking for some helpful guidance on where to look on the board to get that going.