Crusin' USA

ncdeitz

Member
Joined
Dec 23, 2023
Messages
37
Reaction score
26
Picked up a Crusin' sit-down and finally got to looking at it. Basically, it comes on when I flip the switch, I hear two beeps, and nothing else. The monitor was pulled out and they put a VGA monitor in and the converter has a broken pin, so just looking for it to play blind.

I checked the voltages from the power supply and I got what I need. I checked all the fuses, good. Checked the voltages at the connector and I'm good there.

I have no D6 light on the board, and from what I understand the D7 should be off. I'm in the dark with my limited knowledge on this board and am looking for some helpful guidance on where to look on the board to get that going.
 

Attachments

  • PXL_20241223_195437279.jpg
    PXL_20241223_195437279.jpg
    873.9 KB · Views: 4
  • PXL_20241223_195443306.jpg
    PXL_20241223_195443306.jpg
    770.5 KB · Views: 5
left LED is +5V present, right LED should be sound activity. it's probably stuck on the calibrate controls screen because the CMOS battery is dead.
 
Thanks for the input. I replaced that battery and repaired the connector on the converter board and I got the boot up screen where it calibrates the pedals and steering wheel and goes through all the ROM chips.

Now what it's doing is that it gets to the coin up screen where it's black and says three coins to start one credit and it reboots and resets.
 

Attachments

  • PXL_20241223_205236117.jpg
    PXL_20241223_205236117.jpg
    356.9 KB · Views: 3
  • PXL_20241223_205230018.jpg
    PXL_20241223_205230018.jpg
    201.5 KB · Views: 3
left LED is +5V present, right LED should be sound activity. it's probably stuck on the calibrate controls screen because the CMOS battery is dead.
Thanks for the input. I replaced that battery and repaired the connector on the converter board and I got the boot up screen where it calibrates the pedals and steering wheel and goes through all the ROM chips.

Now what it's doing is that it gets to the coin up screen where it's black and says three coins to start one credit and it reboots and resets.
 
Checked out one of mechas previous post and did a double check of my power supply voltage. I tweaked it a little bit to the range that he suggested and it booted right up!

Thank you!
 

Attachments

  • PXL_20241223_211546660.jpg
    PXL_20241223_211546660.jpg
    640.2 KB · Views: 3
Back
Top Bottom