JamBurglar
Well-known member
This is a Sanyo 20EZ that has been recapped and degaussed (using a Waldron degaussing tool).
First, this is a purity issue, right?
Second, is there any chance correcting this will involve adjusting the purity rings only? I'd rather not play around with the yoke positioning unless I absolutely have to.
The monitor is way out of convergence as well but I figure I'll tackle that later. I'm trying to figure out if somebody has messed with the rings or if the yoke was knocked out of its original alignment.
First, this is a purity issue, right?
Second, is there any chance correcting this will involve adjusting the purity rings only? I'd rather not play around with the yoke positioning unless I absolutely have to.
The monitor is way out of convergence as well but I figure I'll tackle that later. I'm trying to figure out if somebody has messed with the rings or if the yoke was knocked out of its original alignment.
