Connector type help?

Andy63

New member
Joined
Jan 11, 2010
Messages
60
Reaction score
1
Location
Maryland
Received 2 of these converter boards CGA/EGA/YUV to VGA HD-Converter
PCB (GBS-8220) picture can be found at Jammaboards.com
http://www.jammaboards.com/store/index.php?act=viewProd&productId=291

In the bottom left corner of the board as seen in the picture is a
large 6 pin connector for medium res (ega) connection. Any info on
what size/ type connector housing and pins it uses would be
appreciated? I could hack something from what I have but would rather
not. This connector does not match any of the standard
pinball type molex connectors. It also does not
match the medium res connector which is a typical connector going to
the current medium res monitors in the Cruis'n USA/World pair I am
attempting to get reliable.
Thank you for help.
Andy
 
Looks like what a lot of TVs use for a yoke connector. Sorry I don't know the name.

If it were me I'd just solder some leads going to a standard monitor plug or at least something you can use.
 
If its not an oddball spacing you might be able to use a standard .156 housing on it.
Worst case you can solder some wires and bring it out to a standard header.
 
Back
Top Bottom