jmduncan
Member
I have reproduced some Coin Controls S-10 selector assembly stickers for the inside of coin doors. I took upon this project when I realized there was no saving my stickers from the inside of my pole position coin doors. I have three left, since I ran out an even sheet so I would not waste material. I also reproduced the coin control inspection stickers commonly found on the doors as well. I have 13 of these left, again to not waste material. Just curious if there would be any interest in these and if there is enough interest I may do more runs. Link below is to restoration post which has pictures. Not sure about a price yet if there is interest in them. Any suggestions would be appreciated.
http://forums.arcade-museum.com/showthread.php?t=226524
http://forums.arcade-museum.com/showthread.php?t=226524