Pookycade2
Member
Does anyone have a crane/ claw machine using this older generation Guan Shing (Guang Shing) board ? If so might you have a manual for the board itself ? This is in a 2007 machine, so I am suspecting this in earlier generation. It was rebranded by Surfnote, a Georgia company that doesn't distribute this anymore and thus no manual. Note I have no VR1, VR2 settings on the board itself so I suspect weak/strong settings are entirely in those dip switches.
So I have a fully working crane but 4 sets of dip switches and not a clue what any of them do. I have pulled up multiple manuals to nearly every damn crane machine out there after searching the internet far and wide. They are not this board. Close but no cigar. In fact I can only find one other post on the entire internet referencing this particular board and showing its picture (asking for how to adjust crane settings not ironically).
Surely somewhere out there must be one of these cranes still in existence (and a manual to go with it). Will pay for the effort to scan for me.
Thanks
So I have a fully working crane but 4 sets of dip switches and not a clue what any of them do. I have pulled up multiple manuals to nearly every damn crane machine out there after searching the internet far and wide. They are not this board. Close but no cigar. In fact I can only find one other post on the entire internet referencing this particular board and showing its picture (asking for how to adjust crane settings not ironically).
Surely somewhere out there must be one of these cranes still in existence (and a manual to go with it). Will pay for the effort to scan for me.
Thanks