chassis ID

tester007

Well-known member
Joined
Jan 14, 2007
Messages
2,609
Reaction score
43
Location
Calgary, Alberta, Canada
Trying to fix this chassis. The frame is a G07 frame, and the crt is a replacement crt but the yoke impedence matches pretty close to a G07 so believe this was one of the replacements they sold.
This chassis matches the Eygo ones 'fairly' close on Bob's site, but not completely (there are 2 versions on his site, both are very close). So I am trying to find out what flyback can go on this, and/or what the value of the resistor is that I have the arrow to. It was burnt in half, and I put one on based off of the schematics for one of the chassis manuals that are out there to download.. but no go. So wondering if someone has the same thing, can meter theirs and tell me what the value is. Everything around it is fine so its either that when it burnt out the chassis failed, or the flyback is dead.

I have found refrence on Eygo monitors to it being common to have a certain resistor commonly fried on the chassis, but those refrences are for chassis different than this. So I am hoping that is all that it is.
 

Attachments

  • chassis.jpg
    chassis.jpg
    82.8 KB · Views: 60
It's an eygo, but not sure which kind. Here's another pic...

attachment.php
 
I've got this one on my Dig Dug, it too is replacing a G07 chassis (also says it is a replacement for a Disco):

DSC01027.jpg


compared to yours:

attachment.php
 
Is that yours mod? I can see red/red on the resistor but not sure if its gold/gold on the end or xx/gold.. anyone ever figure out a compatable flyback?
Not sure what the resistor value is i have but when i put it on, i got high voltage (can't remember how much), but it decreased as i held the probe in to almost nil.
 
Back
Top Bottom