ceronix tube swap

mike11

Active member
Joined
Mar 7, 2012
Messages
1,617
Reaction score
9
Location
Pennsylvania
orig tube yoke reads 2-3 and 17
i have one here from a tatung reads 1.2 and 9

is that too far out to be used or can i get by with it ?
 
orig tube yoke reads 2-3 and 17
i have one here from a tatung reads 1.2 and 9

is that too far out to be used or can i get by with it ?

If that's induction i've learned that you can go 0.1 / 0.150 on the horizontal and 3-5 on the vertical, but at a cost of screen correctness i.e. linearity issues and other geometry problems.

If you're talking ohms.. i wouldn't take that risk as the new one is a lot lower and you might end up smoking the yoke.

You could just swap the yoke if it's not fused..
 
It's ohms , I've never had success swapping a yoke and getting setup right ... I'll pass on that task lol
 
Back
Top Bottom