Museum of the Game® & International Arcade Museum® Forums

I know there have been a lot of posts regarding RGB to VGA conversion but I cannot find an answer to my issue.

The scenario.. I am refurbishing a cabinet that did not have a PCB. The PCB I purchased is supposed to be full functional. I want to confirm video output before I start troubleshooting/repair the CRT and electronics. The CRT currently has very bad output.

I bought the GBS8200 and have it wired to PCB using the Component sync on Pin12. I have a "workable" image but it is all blocky. Edges and details are not proper. I have not seen any posts regarding this type of issue. I have to assume the PCB is not at fault but I currently dont have a way to confirm this.

Thoughts?
Back
Top Bottom