CAPCOM question cps 1 and 2 combo?

martimagico

Member
Joined
Jun 13, 2011
Messages
387
Reaction score
0
Location
Lemoore, California
has anyone here tried or been successful at wiring up a single cab for a cps 1 and 2 on a jamma switcher? i just bought a dynamo that has a super SF 2 and i want to build in my rainbow card with a switcher, i know they have seperate kick harnesses, can i wire them up together to the same buttons if they are both powered on? is there any other way? thanks!
 
has anyone here tried or been successful at wiring up a single cab for a cps 1 and 2 on a jamma switcher? i just bought a dynamo that has a super SF 2 and i want to build in my rainbow card with a switcher, i know they have seperate kick harnesses, can i wire them up together to the same buttons if they are both powered on? is there any other way? thanks!

You'd need to do a complete JAMMA switcher, which I am told are out there, though I haven't used one myself. If you did, you could just wire up both kick harnesses to your buttons and whichever one wasn't turned on wouldn't matter. It should be doable.
 
You'd need to do a complete JAMMA switcher, which I am told are out there, though I haven't used one myself. If you did, you could just wire up both kick harnesses to your buttons and whichever one wasn't turned on wouldn't matter. It should be doable.
that switcher they sell mentions that they are both on simultaneously, i wounder if that would cause interference?
 
I have a similar setup and use this board that jammaboards.com used to sell:
http://www.ebay.co.uk/itm/6-in-1-ar...eo_Games_Coin_Operated_MJ&hash=item27cba552bd

It only sends power to the active board, not sure if thats what you're looking for but i do have several kick harnesses spliced into eachother and successfully working in my cab.

Careful with cheap jamma harness extensions. The wiring is typically shoddy and can cause boards to hang or not work at all.
 
Back
Top Bottom