Capcom Kick harness to 309 in 1 PCB

renorains411

New member
Joined
Nov 2, 2009
Messages
27
Reaction score
0
Location
Nassau, Bahamas
NewComer, wants to swap SF2 EX 2 PCB for 309 in 1 PCB. Form want i understand i will need to move the Capcom Kick Harness wires (which is 8 wires) to the Main Jamma harness.
Here is where i am confused: So do i take the the kick wires and solder them to Jamma harness Pin 25,27,28 for Player 1 and For Player 2 Ac, Ae, Af and take the ground wire for the capcom kick harness and connect it to one of the Jamma Harness Pin A, B, 1, or 2.
 
You should remove the kick harness altogether. If your Jamma harness has the additional wires in place just run those to the buttons and use the common ground that all of the other buttons use. If your Jamma harness does not have the wires installed then you can take them from another harness and install them on the one you are using. Or buy another harness that does have them.

If your harness doesn't have the wire installed then you can't solder any wires to the harness in those spots since there will only be plastic there.
 
Back
Top Bottom