Cap kit a 25k5515 now dead

daughterdad

New member
Joined
May 11, 2008
Messages
445
Reaction score
0
Location
North Carolina
This monitor had a horrible picture so I got a cap kit. I installed it last night and triple checked the positions and ratings of each cap. i checked for bad solder joints and found none. I hooked everything back up and NOTHING! I have 120 to the board but nothing. no neck glow, nothing. What is the next thing I should do?
 
Run along the top edge of the board and make sure you have good solder joints in the 130 volt section. If you didn't address these during the cap kit, you might as well now. There's a real good chance that this is where your problem is but there are a dozen other possibilities as well.
 
Last edited:
Back
Top Bottom