Just purchased this machine and have one of three good PCB's. Any help with IDing it would be appreciated. 2 Boards read 1976...the other reads 1986. I am somewhat mechanically inclined and have got all 3 claws working with the good board...problems left to solve:
1. It's a 2 button crane with fwd and right buttons...one claw goes back...then even though the right light illuminates...you can't go right until you hear a click then it allows claw to go right.
2. Figure out how claw strength is adjusted if it can..as some seem weaker than others.
3. Sent two bad boards out yesterday to Brady Dist, who the boards were stamped with. Hoping they can fix them without breaking me.
4. Middle claw keeps blowing board fuses after 5-10 plays.
Any help or advice would be greatly appreciated...pic of good board and machine attached.
1. It's a 2 button crane with fwd and right buttons...one claw goes back...then even though the right light illuminates...you can't go right until you hear a click then it allows claw to go right.
2. Figure out how claw strength is adjusted if it can..as some seem weaker than others.
3. Sent two bad boards out yesterday to Brady Dist, who the boards were stamped with. Hoping they can fix them without breaking me.
4. Middle claw keeps blowing board fuses after 5-10 plays.
Any help or advice would be greatly appreciated...pic of good board and machine attached.
