i picked up a burgertime UR with issues today on my way home from work. this may just be a long day at work and a mildy frustrating evening getting the best of me, but i cant seem to figure out 2 problems that seem like simple fixes.
please bear with me, as some of this may sound stupid.
1.
it wont coin up. none of the coin switches or service credit button do anything, however when i unplug the harness from the coin door it adds a credit or 2 sometimes, but only just as the pins disconnect. i checked all of the plugs in the harness and it appears to make a good connection, its atleast a nice tight fit and both male and female ends look clean. if the swictches were wired backwards or something, could that make this happen? and there are no broken wires or bad connections anywhere that i can see.
2.
the monitor picture was really blurry and rolling when i got it, and adjustments didnt do a whole lot so i replaced all the caps. after the cap kit i was able to focus the picture, and get most of the colors, however alot of the screen is red, and the bad guys dont really show up, they kind of blend into the red. until i drop down pieces of the burger, then the burgers path is the normal colors with black background. is there an adjustment im missing? or would this be a graphics/board problem?
ive attached a picture of the monitor problem, and its a WG4906
any suggestions are greatly appreciated
please bear with me, as some of this may sound stupid.
1.
it wont coin up. none of the coin switches or service credit button do anything, however when i unplug the harness from the coin door it adds a credit or 2 sometimes, but only just as the pins disconnect. i checked all of the plugs in the harness and it appears to make a good connection, its atleast a nice tight fit and both male and female ends look clean. if the swictches were wired backwards or something, could that make this happen? and there are no broken wires or bad connections anywhere that i can see.
2.
the monitor picture was really blurry and rolling when i got it, and adjustments didnt do a whole lot so i replaced all the caps. after the cap kit i was able to focus the picture, and get most of the colors, however alot of the screen is red, and the bad guys dont really show up, they kind of blend into the red. until i drop down pieces of the burger, then the burgers path is the normal colors with black background. is there an adjustment im missing? or would this be a graphics/board problem?
ive attached a picture of the monitor problem, and its a WG4906
any suggestions are greatly appreciated
Last edited:
