Last week I was fortunate enough to trade with
@alyles81 for his project paperboy. After a very enjoyable 16 hour drive me and paperboy are home safe and sound, I have started to try to get it working. Thankfully alyles81 left me with almost all of a harness, and after comparing CS and PB I got the board and power supply all wired up.
This Left with the bigger part of the puzzle finding the right monitor. So I headed off to a friend barn and spent most of an afternoon hunting for a medium rez monitor. I found a sharp monitor but it was missing it's adjustment board but I ended up finding a digital wells gardner 19" inch. I got the monitor home and went to slid it in the cab to find someone had bend the mounting bracket, so after a little re bending it pop into place.
At this point I started to check the boards and voltages coming from the power supplies and everything was looking great, but in my looking at other peoples wiring I noticed that I was missing 5 chips from the between the two boards. A pokey chip, 6116 ram chip and 3 eproms. I have found a replacement ram and pokey chip from another board and hopefully
@Supergun is going to burn me the 3 missing chips.
My next step will be starting to reassemble the handlebars and wire up a harness for it. I know that Cs control harness is different the paper boy and as long as I'm having to build a CP harness am I best off just building it to have the 2 connectors and skip needing the adapter.
For now here are some photos of the progress so far.