Broke a convergence ring tab on a WG75000

Sbeehive

Member
Joined
Sep 17, 2012
Messages
233
Reaction score
2
Location
Rhode Island
Hey all,

Was adjusting the conversion on my WG 7500 series monitor today because it was starting to look like 3d glasses.

Tragically, one of the convergence tabs broke.

Its still quite movable- but its kind of a pain. Does anyone know where/if they sell extras of those?

Thanks,

Sbeehive
 
Hey all,

Was adjusting the conversion on my WG 7500 series monitor today because it was starting to look like 3d glasses.

Tragically, one of the convergence tabs broke.

Its still quite movable- but its kind of a pain. Does anyone know where/if they sell extras of those?

Thanks,

Sbeehive

Can you glue the tab back on?
 
Right now Im putting the tab back where it was to move it. Glueing it could be an option... its just tricky because it could end up glueing to the part its supposed to move on than itd be screwed
 
Right now Im putting the tab back where it was to move it. Glueing it could be an option... its just tricky because it could end up glueing to the part its supposed to move on than itd be screwed

Use rubber cement on top to hold 'em in place. Easy to peel back when you need to readjust again.
 
other than what has been suggested your only other option is a new set of rings.

find a doner TV and have at.

Peace
Buffett
 
Looks like rubber cement it is for now until I can find an old TV to mutilate haha.

Thanks all
 
Back
Top Bottom