Blurry Monitor After Game Runs for awhile?

Tanass504

New member
Joined
Feb 23, 2013
Messages
31
Reaction score
0
Location
Georgia
When I turn on the Cruisin USA the picture is perfect, I noticed that if I left it on, or played it for more than a couple hours, my monitor got noticeably more blurry then when I first powered on the machine? Any suggestions
 
adjust it once hot. It will then be blurry untill warmed up.

Let us know what kind of monitor si in it. if its a neotec, there is a revised flyback for some neotec
models that corrrects this issue.

Could also be that you need to do a capkit, or could be the tubs is getting weak too. Until we know what monitor you have, cant really offer any more advise.
 
adjust it once hot. It will then be blurry untill warmed up.

Let us know what kind of monitor si in it. if its a neotec, there is a revised flyback for some neotec
models that corrrects this issue.

Could also be that you need to do a capkit, or could be the tubs is getting weak too. Until we know what monitor you have, cant really offer any more advise.

If it is a Crusin USA sitdown, it is probably either a wells 7500 or a U5000.
 
Most of the Crusin USA cabs I've seen came with wells k7500 medium res monitors.. Neotec prolly too, but I've got half a dozen k7500s that all came out of some sort of Crusin game..

Flyback is bad.

If it slowly looses focus after the game has been on for a little while try adjusting the control on the fly.. Then if its loosing focus, replace the flyback. These tubes are pretty decent, so I'm sure its the fly. Also replace the caps while you have it out of the game.. Make sure to re-install the black wire that wraps around the same way its there now.. I had an issue with the first one I did as I didn't wrap it exactly the way it was.. Wasted hours trying to figure out what was wrong
 
youre likely going to want to replace the fly and or do a capkit while its out. But of course if you can adjust it to some happy medium you can live with, then why not.
 
Ya i adjusted while the machine was hot and it seems to be holding .. lol looks like crap until it heats up but thats not long .. ya ill have to replace sooner then later.. have issues with force feed back to but thats another story, game drives fine but I dont feel any feedback driving, turning or crashing ... and when i do self test the wheel is supposed to move by its self during test and it doesn't.. but im happy for now
 
adjust it once hot. It will then be blurry untill warmed up.

Let us know what kind of monitor si in it. if its a neotec, there is a revised flyback for some neotec
models that corrrects this issue.

Could also be that you need to do a capkit, or could be the tubs is getting weak too. Until we know what monitor you have, cant really offer any more advise.

I have a Neotec that gets blurry after awhile. I just capped it and so far so good, I will put a flyback in too. Where can i find more info on the issue with the Neotecs ?
 
i honestly dont remember i think chad@arcadecup was talking about it.. the neotec tubes go slightly weak, old flys cane make quite enough hv, blurry pic. Replacement flys make a little more juice to correct the issue.
 
Back
Top Bottom