BK 467 CRT Tester/Rejuvenator

channelmanic

Well-known member

Donor 3 years: 2011-2013
Joined
Apr 5, 2008
Messages
17,110
Reaction score
1,093
Location
Texas
Rating - 100%
166   0   0
FS: 1 BK 467 CRT Tester/Rejuvenator

Freshly repaired - replaced 1 resistor in the meter circuit which was needed to set G1 voltage.

Comes with the following adapters: 1, 2, 3, 4, 5, 6, 16, 22, 23, 24, and a modified #26.

Not sure what they modified the #26 to be as it went from a 12 pin socket to a 10 pin. The old socket is included if you want to restore it back to a #26.

Comes with the manual and 3 revisions of tube setup guides, but you'll want the newer .pdf version off their website to get the later tubes...

$100 shipped CONUS.
 
Took my 467 apart the other week and I'm not sure how you repaired anything in that mess. I couldn't even get it reassembled properly from what I can tell.
 
Took my 467 apart the other week and I'm not sure how you repaired anything in that mess. I couldn't even get it reassembled properly from what I can tell.

What is yours doing? There are 2 LONG Molex pin connectors inside it and they always have cracked solder joints from the crappy factory soldering. You should resolder those and test it again.

Ken was nice enough to email me the high res scans of the schematics so I can use those to help you troubleshoot it.

Also, where in Dallas are you? I'm up in Highland Village.

RJ
 
Back
Top Bottom