Big buck hunter

DURANGOKING

Member
Joined
Nov 3, 2010
Messages
160
Reaction score
3
Location
kenosha, Wisconsin
Just rebuilt the machine from monitor to gun.
worked sweet for 10 min then gun doesn't work or works intermittent
Could this be a I/C chip on the board?? .. new gun, sensor, etc
HAS ANYBODY REPLACED THIS CHIP..?

THANKS
 
Last edited:
Without knowing some more details, i can't say:

a) Did you replace the entire gun, replace the optic board, just clean it, what?

b) You redid the monitor? How's the brightness, contrast, ambient lighting in the room, etc? Does it need degaussing?

c) Does the gun work better up close than far away? If so, check the +5 to the gun's optic board. it may need to be turned up.

d) how's the gun calibration screen work?

e) Did you clean the monitor tube and bezel glass (inside and out)?
 
Without knowing some more details, i can't say:

a) Did you replace the entire gun, replace the optic board, just clean it, what?

b) You redid the monitor? How's the brightness, contrast, ambient lighting in the room, etc? Does it need degaussing?

c) Does the gun work better up close than far away? If so, check the +5 to the gun's optic board. it may need to be turned up.

d) how's the gun calibration screen work?

e) Did you clean the monitor tube and bezel glass (inside and out)?

THANKS FOR REPLYING

YES the gun is brand new worked flawless for an hr or 12 beers worth of shooting.
Monitor is brand spanking new perfect color. beautiful picture great room lighting,
It calibrated perfect not no high not no low dead nuts. The voltage is dead nuts 5 .
Everything monitor wise is super clean .
I went to recalibrate, it says invalid shot it shoots and pumps but no hit markers.
I'm at a loss until I read about a I/C chip on the board I guess its a commom problem .this game is full of problems

Thanks for listening
Justin
 
Back
Top Bottom