Zinfer
Well-known member
Coming back to a Battlezone project cab, I found that the rectifier had been pulled from the power brick. I ordered a couple more to keep one on hand for the next time this happens. GBPC3502 35A 200V from Mouser recieved. Mounted it to the chassis and plugged in the appropriate wires thinking this should get my power I need to the ARII board.
So I plug in main power, and only get 24v to the ARII. no 5's or 12's.
I was wanting to just run a few measurements from the power bricks' 15 pin connector that leads to the harness. Is there a link available for that?
I don't seem to be getting much of anything other than 24volts everywhere.
So I plug in main power, and only get 24v to the ARII. no 5's or 12's.
I was wanting to just run a few measurements from the power bricks' 15 pin connector that leads to the harness. Is there a link available for that?
I don't seem to be getting much of anything other than 24volts everywhere.