Baby Pac Vidiot«**»MPU cable

Tighe

Well-known member
Joined
May 25, 2009
Messages
20,797
Reaction score
825
Location
Richmondville, New York
I have a Baby Pac that I planned on beig a winter project, but as spring is getting closer I realize that I need to take some shortcuts.

Does anyone sell premade Vidiot to MPU cable? From what I understand that is a common problem even though mine looks good.

I can make my own but would take time to do.

Also people have said to use different conectors instead of the original style. Anyone got a link to where to buy, preferable from mouser or digikey?
 
Thanks, I have seen that, so no one knows of a place where I can buy the cable or the connectors?

You can get the connectors from your favorite electronics place like Mouser, etc. You just need to lookup the right connector size and pin count for the header you are wanting to replace. I replaced a few, but was not thrilled with the new replacements I picked. The pin spacing is obvious when you look at the manual for the headers in question. The size is in the part name that is listed. I'm not aware of a site that list the parts to order, so you will likely just have to figure it out yourself.
 
You can get the connectors from your favorite electronics place like Mouser, etc. You just need to lookup the right connector size and pin count for the header you are wanting to replace. I replaced a few, but was not thrilled with the new replacements I picked. The pin spacing is obvious when you look at the manual for the headers in question. The size is in the part name that is listed. I'm not aware of a site that list the parts to order, so you will likely just have to figure it out yourself.

Thanks, I can do it, just hoping for a part #.
 
Bump on this, anyone know the part #s I would need for the connectors? I will pull this out at some point and measure the pitch and pin #, but if anyone know this already it would be helpful.
 
Back
Top Bottom