Baby PAC flipper issues....

kerri369

Active member
Joined
May 3, 2009
Messages
2,375
Reaction score
23
Location
brentwood, New York
I posted in the video game section, but I may get more help here. The right flipper and ball kickout doesn't work at all, but the left one works fine. I also get not activation during the self test.. Where should I start looking? Thanks....
 
does the communication test come back good?

if so it could be the flipper relay is bad,

outhole kicker is your q37 2n6045 transistors on driver board.. you can test that transistor with a DMM..

sometimes just taking off the connectors and re seating them may help.
 
If you haven't in a while i would remove all the connectors on the three main boards and re seat them. you can even wipe them down with a little alcohol.

When is the last time these two solenoids worked?

Have you tried a continuity test down the wires?
 
the flipper was working up into a month ago, but before that it would make that rapid "machine gun" motion when pressed. and never did a continuity test.
 
Back
Top Bottom