B+ Sanyo - Voltage Close Enough ?

ScumBum

Well-known member
Joined
Jun 18, 2008
Messages
5,240
Reaction score
395
Location
California
I tested the B+ on my two Nintendo games [With Dokerts handy tool which rocks!] and got a reading of 108.6 and on the other 108.5 , is this close enough ?

If I need to adjust it to exactly 108 do I use a plastic tool or can I use a screw driver ?

That spot where the pot is looks mighty scary........
 
Consider yourself lucky. I have three 20EZ's here with different B+ voltages

1) Working - 108.1
2) Dead - 131.8
3) Dead - 22.8

Haven't found a difference between them yet, and I've reflowed everything at least twice...
 
Consider yourself lucky. I have three 20EZ's here with different B+ voltages

1) Working - 108.1
2) Dead - 131.8
3) Dead - 22.8

Haven't found a difference between them yet, and I've reflowed everything at least twice...

Holy crap ! Thats sucks ! Yeah I was surprised the voltages on mine were good . I gave them both cap kits too . One of them has a rock solid picture no problems at all . The other one loses sync sometimes so I thought maybe the B+ was off , but its not so I'm gonna install the Pot replacement kit from Bob roberts next .
 
Back
Top Bottom