B&K Adapter for a G05-805

jetusenet

Well-known member

Donor 4 years: 2011, 2013-2014, 2024
Joined
Feb 26, 2006
Messages
7,234
Reaction score
743
Location
Staten Island, New York
Hi;
I want to test a 15" CRT, it's in a G05-805 and the CRT is a 15ST4730R.
I checked the B&K manual and it does not list this CRT specifically in the chart.
It seems that there are two choices for 15" B&W CRTs, a #6 and a #10. I have the #6 and it fits but do not have the #10 to compare.
I checked the Forums and could not find a similar situation to compare notes.....

Does anyone know what adapter should be used on the 15ST4730R CRT, I do not want to just fire it up, in case it just "Fires-Up!"

Thanks in advance
Jeff
 
Black and white monitors are sometimes listed differently in the manual. What you have is a 15" ST4730 series monitor. If you look up ST4730 in the black and white section of the chart you'll find that it uses the CR6.
 
...and for the noobies, I'll add......the set up charts don't always call them "black & white".......sometimes it's "monochrome".

Edward
 
Excellent!

I am super psyched that I have the correct adapter, I was dreading having to fabricate yet another.......

I went back to the paper manual and still did not see the listing you had mentioned, then I remembered that I had the PDF. Sure enough, at the end of the document, the listing for the ST4730...

Another reason I was apprehensive, the CRT plug has one more wire than the adapter has.....

Anyway, thank you very much and I am now going to print this PDF and place it in the Rejuv box with the original manual so this won't happen again.

Jeff
 
What I've been reading is that all B/W tubes use the same pin-out and thus the same adapter.

Tried mine on three diff. B/W tubes and indeed all fine.

All 19"ers are the same....as is most of the others, but I'd double check if it wasn't a 19" or an oddball one I've never seen. I know the ones in my Subs IS NOT a CR6.

Edward
 
Back
Top Bottom