Aztec pinball will not end play

XY4u

New member
Joined
Sep 6, 2006
Messages
287
Reaction score
3
Location
Kansas
I have an 1976 Williams Aztec pin that once you start a game or four it will play forever. I can maually reset the scores with the right relays but there is somthing wrong with the ball count to end the game. That is to say once it sees the ball in the outhole it will always put the ball back in the shooter lane after a drain. Any ideas??
 
Last edited:
Have you gone through this game? Are all your step units clean and free moving? Love the old service techs - oil, oil, oil and 30 years later it's like super glue. Check your game over relay contacts. But I'm guessing step units.
 
I have an 1976 Williams Aztec pin that once you start a game or four it will play forever. I can maually reset the scores with the right relays but there is somthing wrong with the ball count to end the game. That is to say once it sees the ball in the outhole it will always put the ball back in the shooter lane after a drain. Any ideas??
Does it count up the balls on the back glass or just stay on ball #1? Either way I'd bet it's the ball count unit that is not rotating properly. Also could be the game over relay. Also post this in the Pinball section so some more of the pinball guys will see it.
Glennon
 
Last edited:
Back
Top Bottom