Atari Millipede card board bezel pattern

Anyone know how to make these? I have no source to work with.

A pattern would be nice.

Because the monitor in that cab isn't original, I'd just cut a standard bezel, don't try to get fancy. Measure the monitor area and the spacing L/R/T/B and you should be able to approximate it. Just leave enough material L/R to make flaps to secure it in place. If we hadn't done our swap last minute, I would have had that cut. Good luck!

Chris
 
Because the monitor in that cab isn't original, I'd just cut a standard bezel, don't try to get fancy. Measure the monitor area and the spacing L/R/T/B and you should be able to approximate it. Just leave enough material L/R to make flaps to secure it in place. If we hadn't done our swap last minute, I would have had that cut. Good luck!

Chris

Ok, just just a flat one?
 
Back
Top Bottom