Atari connector - where can I get it?

joeycuda

Well-known member
Joined
Aug 17, 2009
Messages
14,522
Reaction score
990
Location
Madison, Alabama
I hope someone can help me out. I'm not looking for any 2 pin connector, but trying to figure out EXACTLY which one for the speaker/speaker connector in a Crystal Castles upright. In my CC cabinet, the speakers/wiring are missing and the harness is clipped at the connector, leaving only the white and brown wires.

I can't find a pic online of a CC in that spot, but found a pic of a Millipede and I'm thinking it would be the same connector. Is it AMP, Molex? On the GPE site, the 0.084 looks similar, but I don't think it's the same housing.

It's on the upper right in this Millipede cabinet photo, with a white and a brown wire. Thanks in advance!

IMG_0759.JPG
 
Looks like a 2 pin molex connector.... Fry's has them if your near one...

I would use the 2-Pin, 0.062"

-Mike
 
I just use some male/female quick disconnects. it doesn't matter if you use these, solder or the original connector. it's all the same and it won't raise or lower the value of the game if that's what you're thinking.
 
FYI, I recently restored 3 different Tempest cabs. Each had (from what I could tell) the factory wiring still present but one of the cabinets had a different plug going up to the speakers.

They all were 2 wire -- just one with a different connector. Sorry I don't know the details off the top of my head but my guess would be that they changed plugs over time and there might not be a 'correct' one.
 
Back
Top Bottom