FS Parts: Atari brick power supply - 3 available

What are the numbers stenciled on the sides of the transformers on the power bricks? They are somewhat game dependant.
 
They came from an operator's warehouse, untested. Can't tell you what games they came out of, probably an older vector game because it does not have a bridge rectifier attached, only the board attached to big blue with the 2 large diodes (all are good) as the pictures show. The number stenciled on the transformer (all 3) is

RAVENSWOOD
42-71410
37-8013
ELECTRONICS

The middle 9 pin molex connector on 2 of them are missing but the wires and their molex pins are intact underneath.
 

Attachments

  • P1010151.jpg
    P1010151.jpg
    100.6 KB · Views: 148
  • P1010153.jpg
    P1010153.jpg
    100.3 KB · Views: 117
  • P1010154.jpg
    P1010154.jpg
    100.5 KB · Views: 107
I believe them to be for an Atari B&W vector as well but cannot confirm just yet. Since it is pickup only, I am out of the running.
 
did I send the right xfmr numbers? It's the only ones I see on it. Also, I would say I'd ship it if it's worth it to you but I would want to sell all 3 and that doesn't leave me any room for a better offer.
 
Still have the pictured 3 power supply bricks - According to the Elecktron Forge Transformer Assembly Guide http://www.elektronforge.com/transassy.htm (#4 at the bottom), the transformer assembly is for an early Asteroids or a Lunar Lander. I'd prefer pick-up but recently calculated shipping to be $50. Alll 3 shipped for $125 or pickup for $60.
 
Back
Top Bottom