ARII in my Centipede, not getting 36v...

keithsarcade

Well-known member
Joined
Nov 27, 2008
Messages
8,875
Reaction score
160
Location
St Peters, Missouri
The 36v test point on my ARII is only reading 17.4. Other test points are only slightly off, -22v is reading -23.4, 10.3v is reading 11.3, 12v is reading 11.7 and -5v is spot on. I believe the lack of 36v might be affecting the HSS circuit. Any ideas? Anyone think a rebuid kit for the ARII might be the answer, or even a big blue?
 
The 36v looks like it is working fine, otherwise you would not have +22v and -22V. The board takes the +22v and the -22v and runs it through two regulators on the board. Check to make sure you have +15v and -15V on the board coming out of those regulators.

-Brian
 
You are measuring the 36vac incorrectly. When you measure the 36vac to ground you will get approximately half of the correct value.
 
Back
Top Bottom