Ar2 resistor question

Big Arn

Member
Joined
Sep 19, 2008
Messages
239
Reaction score
5
Location
Maryland
I have a few Atari AR2 boards with a bad cement power resistors.

One is CB10 22ohm 10w 5%, and the other is CB7 .1ohm 7w 3%.

Do these have to be replaced with the same tolerance values? The 7 watt resistor seems to be a little tough to find.

Thanks!

-- Bruce
 
Thank you for the responses.

Mouser seems to have everything, but the .1 ohm 7W resistors listed in the post above are all 5% tolerance, where all the AR2 boards I have here have 3% tolerance parts.

I assume the 5% tolerance will be OK?

The schematics of the AR2 board doesn't even list tolerances for these resistors -- just the ohmage and wattage.

Thanks again!

-- Bruce
 
Back
Top Bottom